Description

Bradford White RG2 Residential Manufactured Power Direct Vent Gas Water Heater are extra efficient, reliable and safe to operate. Model Manufactured Manufactured Power Direct Vent Gas Water Heater include Defender Safety System® – has proven itself a top pick year after year. Millions of homeowners count on these quality gas water heaters for exceptional performance and reliable hot water.

The Power Direct Vent Models Feature:

• ENERGY STAR® Qualified—Some models meet or exceed requirements for ENERGY STAR® per the latest ENERGY STAR® criteria revision, as well as most utility rebate programs.
• Bradford White ICON System™—Intelligent gas control with spark to pilot ignition system eliminates the constant burning pilot. This results in savings of pilot gas during standby
  periods (120 VAC).
  Enhanced Performance—Proprietary algorithms provide enhanced First Hour Rating and tighter temperature differential.
  Advanced Temperature Control System—Microprocessor constantly monitors and controls burner operation to maintain consistent and accurate water temperature levels.
  Intelligent Diagnostics—An exclusive green LED light prompts the installer during start-up and provides ten different diagnostic codes to assist in troubleshooting.
  Pilot On Indication—Flashing green LED provides positive indication that pilot is on.
  Separate Immersed Thermowell—High-strength advanced polymer composite thermowell provides isolation between electric temperature sensor and surrounding water. No need to drain the tank when removing gas valve.
• Closed Combustion Venting System—Power Direct Vent models are ideal for installations which lack sufficient air for combustion, such as new construction homes or additions which are tightly insulated. These models use a twin pipe system where combustion air is drawn from outside the building in one pipe, and combustion products are expelled to the outside in another pipe.
• Cast Aluminum Air Intake Boot—A cast molded air intake boot design provides exceptional durability during installation and operation.
• Horizontal and Vertical Venting—PVC, ABS, or CPVC. The equivalent feet of intake venting cannot be greater than the equivalent feet of exhaust venting.
• Optional Concentric Vent Kit Termination—Termination fitting provides for only one exit opening through a wall or roof. (Subtract 10ft. (3m) for intake pipe and 10ft. (3m) for exhaust pipe when calculating total vent length.)
• Flammable Vapor Sensor—Electronic sensor prevents burner operation if flammable vapors are detected. The sensor will also prevent operation if there is ongoing flammable vapors burning inside the combustion chamber (excluding RG2PDV75H6N).
• Factory-Installed Hydrojet® Total Performance System—Sediment reducing device that also increases first hour rating of hot water while minimizing temperature build-up in tank.
• Vitraglas® Lining—An exclusively engineered enamel formula that provides superior tank protection from the highly corrosive effects of hot water. This formula (Vitraglas®) is fused to the steel surface by firing at a temperature of over 1600°F (871°C).
• Insulation System—2″ (51mm) Non-CFC foam insulation covers the sides and top of the tank, reducing heat loss. This results in less energy consumption, improved efficiencies, and jacket rigidity.
• Water Connections—3⁄4″ (19mm) NPT factory-installed true dielectric fittings extend water heater life and simplify water line connections.
• Side Connections—3/4″ (19mm) NPT tappings allow easy connections for space heating applications (Potable water only) (RG2PDV50H6N & RG2PDV75H6N only).
• Factory Installed Heat Traps—Design incorporates a flexible disk that reduces heat loss in piping and eliminates the potential for noise generation.
• Protective Magnesium Anode Rod—Provides added protection against corrosion for long-term, trouble-free service.
• T&P Relief Valve—Installed.
• Low Restrictive Brass Drain Valve—Durable tamper proof design.
• NOx Emissions—Less than 40 ng/J.