Authorized Micro-Air dealer · DuPage County, IL
Micro-Air EasyStart & EasySurge Dealer Serving DuPage County, IL
GSHA Services, LTD is an authorized Micro-Air dealer and installer serving DuPage County from our offices in Woodstock (McHenry County) and Lake Bluff (Lake County); we have no office in DuPage. Our own licensed electricians install the EasyStart Flex soft starter and the EasySurge Guardian surge protector on central air conditioners and heat pumps in Wheaton, Glen Ellyn, Lombard, Elmhurst, Carol Stream and the other communities on our list.
DuPage housing is older than most of our service area: the median home was built in 1978, and 83.0 percent of occupied homes heat with natural gas, 14.7 percent with electricity and 1.1 percent with bottled or LP gas (U.S. Census Bureau, ACS 2020-2024). That means many homes have a gas furnace paired with a conventional central air conditioner, often on the original electrical panel, and that is where a soft starter and a careful look at the AC circuit pay off, especially when a generator is part of the plan. Call (224) 220-3660 or request a free in-home visit.
Communities we serve in DuPage County
Our published service area includes Addison, Bensenville, Bloomingdale, Carol Stream, Elmhurst, Glen Ellyn, Glendale Heights, Itasca, Lombard, Roselle, Villa Park, Warrenville, West Chicago, Wheaton (the county seat), Winfield and Wood Dale. Several covered towns cross county lines: Aurora extends into Kane and Will, Bartlett into Cook and Kane, Bolingbrook and Naperville into Will, Hanover Park into Cook, and Lemont into Cook and Will. The permit office and, for Naperville, the electric utility depend on which side of the line your house is on.
Downers Grove, Woodridge, Hinsdale, Lisle, Westmont and Oak Brook are also on our ZIP list, and our crews have worked there recently. Burr Ridge is not named on it, although its 60527 ZIP code is listed; if you live there, please confirm your address before scheduling. The full list is on the service area page.
Why a soft starter makes sense in DuPage County
Older houses, conventional compressors
With a 1978 median build year, a typical DuPage house is on its third or fourth air conditioner, and most of those replacements were conventional single-stage or two-stage units. Micro-Air lists the EasyStart Flex for single-phase residential compressors up to 6 tons, including two-stage compressors and heat pumps, with TXV, EEV or fixed metering, and rates it at up to a 75% reduction in start-up current. That reduction shows up as less light flicker on utility power and, more importantly, as a much smaller demand on a generator. Variable-speed systems are not on Micro-Air’s list, so we confirm the type from your model number.
Generators on established lots
Many DuPage homeowners add a standby generator years after the air conditioner went in, or add central air to a home whose generator was sized for essentials. In either case the compressor’s starting surge is often the number that decides the generator size. A soft starter lowers that number, and Micro-Air’s sizing guide is clear about the limits: starting watts are assumed to be about 1.4 times running watts, no other significant loads are assumed to be running when the compressor starts, and compressor amps vary by manufacturer. We check your generator, transfer equipment and panel before telling you whether it closes the gap.
Heat pumps and dual fuel
About one DuPage home in seven heats with electricity, and gas homes increasingly add a heat pump for dual-fuel heating. A heat pump runs its compressor year-round, so a soft starter works in winter as well as summer. Equipment options and DuPage HVAC permit details are on our Lennox page for DuPage County.
Surge and voltage protection
The EasySurge Guardian mounts outdoors next to the AC disconnect, suppresses surges with a 50 kA single-strike rating, and disconnects the outdoor unit when voltage goes above or below adjustable limits (125 to 280 volts high, 80 to 230 low), reconnecting after a delay of 5 to 600 seconds. Its app logs the last 32 events, which helps when an older system has unexplained trips.
Permits and electrical rules in DuPage County
DuPage municipalities spell out more about the air conditioner’s electrical connection than most. When Micro-Air equipment goes in with a new air conditioner, heat pump or generator, it is covered by that project’s permit; for an add-on to an existing system, we confirm with the local building department and pull a permit when required. What the local offices publish:
- Wheaton. The city’s Furnace & Air-Conditioner – Residential page calls for a rough inspection for new electrical work, then a final, and requires a properly sized UL-listed breaker plus a nearby disconnect for a new air conditioner. Those are the same two parts our electricians check before adding a soft starter or surge protector.
- Glen Ellyn. The Work That Requires a Building Permit sheet names AC condensers and heat pumps, and the village’s What Application to Use table makes a coil or compressor swap an over-the-counter permit, while a full replacement is a small permit with plan review.
- Lombard. The Residential A/C Condenser Requirements handout requires a permit and a final HVAC inspection and calls for working clearance around the condenser of 24 inches at the sides, 30 in front and 12 at the rear. We keep a surge protector and its conduit clear of that space.
- Downers Grove. The village Permits page says most projects require a permit and that applications and inspection requests go through the online portal only.
- Unincorporated DuPage County. The Building and Permits page lists air conditioner replacement among online permits, the Permits and Forms page says work shall not start before the permit is issued, and contractors must be registered with the county first.
Other municipalities run their own building departments; we confirm the process for your village at the estimate.
What our electricians check at the outdoor unit
In a 1970s house the AC circuit may be original. Before adding a Micro-Air device, a GSHA electrician confirms the breaker against the outdoor unit’s nameplate, checks the disconnect, conduit and grounding, and looks at the panel the circuit comes from. The EasySurge Guardian mounts next to the disconnect with two half-inch conduit connections, and the EasyStart Flex is wired between the supply and the compressor. Our HVAC technicians check the compressor, capacitor and contactor first, since a soft starter is not a repair for a failing part.
Electric utilities and outages in DuPage County
ComEd delivers electricity in Wheaton, Glen Ellyn, Lombard and most of the county, and outage status is on ComEd’s outage map. The exception is Naperville, where most homes are served by the city’s own municipally owned electric utility; the Naperville Department of Public Utilities appears on the American Public Power Association’s list of Illinois public power utilities. Naperville Electric customers report outages to the city.
The Micro-Air equipment works the same on either supply. We do not quote outage statistics; the planning question is what you want running when the power is out, and whether the generator can start your air conditioner.
Pairing Micro-Air with a generator in DuPage County
We install home standby generators throughout DuPage County. The county generator pages cover Nicor Gas meters, permits and placement on established lots: see KOHLER generator installation in DuPage County, Generac in DuPage County, Briggs & Stratton in DuPage County and Champion in DuPage County.
- Generator first, cooling later. If your generator was sized for essentials, a soft starter may let it start the air conditioner as well, provided the running load fits. We check before promising.
- New air conditioner on an existing generator. A larger or second compressor can exceed what the generator was sized to start. A soft starter or load management may avoid a generator replacement.
- Portable generator. It must connect through a transfer switch or interlock, which our electricians install. Central air on a portable is often impossible without a soft starter and sometimes impossible with one; we tell you which.
Our generator installation page describes the full process.
Micro-Air products we install in DuPage County
The same two Micro-Air products are available county-wide. Full specifications are on the main Micro-Air page, and a shorter overview is on our EasyStart and EasySurge Guardian page.
EasyStart Flex
Soft starter for home air conditioners and heat pumps up to 6 tons; up to 75% less start-up current, per Micro-Air.
ASY-398-X1S-BL
EasyStart detailsEasySurge Guardian
Surge and over/under-voltage protection for 240-volt HVAC equipment, mounted beside the AC disconnect.
ASY-720-X01
EasySurge detailsGenerators
Standby generator installation across DuPage County.
KOHLER, Generac, Briggs & Stratton, Champion
Generators in DuPage CountyAC & heat pumps
New central air and heat pump systems, with the Micro-Air add-ons quoted at the same visit.
Lennox, Carrier and other brands
AC and heat pumps in DuPage CountyMicro-Air offers
Ask GSHA about current Micro-Air offers.
Financing through our lending partners is described on the financing page.
DuPage County questions and answers
Which GSHA office serves DuPage County?
Crews come from our Woodstock and Lake Bluff offices. We have no office in DuPage County.
My house is from the 1970s. Is a soft starter a good idea?
It often is, because older central air conditioners usually have conventional compressors that Micro-Air lists as compatible. But in an older house we check the compressor, capacitor, contactor, breaker and disconnect first; a soft starter will not fix a failing part, and an undersized or worn circuit should be corrected before anything is added.
I live in Naperville. Does Naperville Electric affect the installation?
No. The Micro-Air devices work the same on any 240-volt supply. Naperville Electric customers report outages to the city rather than ComEd.
Will Wheaton require anything special?
Wheaton’s residential AC page calls for a properly sized UL-listed breaker and a nearby disconnect for a new air conditioner, with a rough inspection for new electrical work. When Micro-Air equipment is part of a new system, it is inspected with it; for an add-on alone, we confirm with the city.
Will it let my generator run my air conditioner?
Often, if the generator has enough running capacity and only the starting surge is the problem. Micro-Air rates the reduction at up to 75% of start-up current. We compare your generator’s rated output with the compressor and your other loads.
Can you install it on any brand of air conditioner?
Yes, on single-stage and two-stage systems and heat pumps up to 6 tons. Variable-speed systems are not on Micro-Air’s compatibility list.
Other counties we serve
Back to the main Micro-Air page, or choose another county.
Request a free Micro-Air installation estimate
Tell us about your air conditioner or heat pump in DuPage County, your generator if you have one, and what you want to solve. We will follow up to schedule a free, no-obligation in-home visit, check the equipment and electrical circuit, and give you a written quote.
Send the form or call
Use the form here, book online, or call (224) 220-3660.
In-home visit
A GSHA technician reads the nameplates, checks the circuit and explains which Micro-Air products, if any, fit your goal.
Written quote
You receive an itemized quote with the equipment, any permit and the work included. No obligation.
If the form does not load, email info@gshaservices.com or call (224) 220-3660.
About GSHA Services, LTD
GSHA Services, LTD is a licensed and insured heating, cooling, electrical, plumbing and generator contractor and an authorized Micro-Air dealer and installer. GSHA Services is an independent company and is not Micro-Air, LLC; product warranties are provided by the manufacturer. Offices: 1257 Cobblestone Way, Suite A, Woodstock, IL 60098 and 11 N Skokie Hwy, Lake Bluff, IL 60044. Phone (224) 220-3660. Email info@gshaservices.com. See the full service area by ZIP code. Contact us · Financing · All products and brands
Sources
- Micro-Air, EasyStart Flex Home AC Soft Starter product page — https://www.microair.net/products/easystart-flex-home-ac-soft-starter (accessed 2026-10-23)
- Micro-Air Knowledge Bank, Sizing a Generator — https://www.micro-air.com/kb-easystart/article_presales/easystart_Selecting_a_Generator.htm (accessed 2026-10-23)
- Micro-Air, EasySurge Guardian HVAC Surge Protector product page — https://www.microair.net/products/easysurge-guardian-hvac-surge-protector (accessed 2026-10-23)
- Census Reporter, ACS 2020-2024 5-year tables B25035 and B25040, DuPage County — https://api.censusreporter.org/1.0/data/show/acs2024_5yr?table_ids=B25035,B25040,B25003&geo_ids=05000US17043 (accessed 2026-09-16)
- City of Wheaton, Furnace & Air-Conditioner – Residential — https://www.wheaton.il.us/813/Furnace-Air-Conditioner—Residential (accessed 2026-09-16)
- Village of Glen Ellyn, Work That Requires a Building Permit — https://www.glenellyn.org/DocumentCenter/View/2329/Work-That-Requires-A-Building-Permit- (accessed 2026-09-16)
- Village of Glen Ellyn, What Application to Use — https://www.glenellyn.org/DocumentCenter/View/1744/WHAT-APPLICATION-TO-USE (accessed 2026-09-16)
- Village of Lombard, Residential A/C Condenser Requirements — https://www.villageoflombard.org/DocumentCenter/View/133/AC-Condensor-Requirements-PDF (accessed 2026-09-16)
- Village of Downers Grove, Permits — https://www.downers.us/permits (accessed 2026-09-16)
- DuPage County Building & Zoning, Building and Permits — https://www.dupagecounty.gov/government/departments/building_and_zoning/building_and_permits/ (accessed 2026-09-16)
- DuPage County, Permits and Forms — https://www.dupagecounty.gov/government/departments/building_and_zoning/building_and_permits/permits_and_forms.php (accessed 2026-09-16)
- DuPage County, Contractor Registration — https://www.dupagecounty.gov/government/departments/building_and_zoning/building_and_permits/contractor_registration.php (accessed 2026-09-16)
- City of Naperville, Electric Utility — https://www.naperville.il.us/services/electric-utility/ (accessed 2026-09-16)
- American Public Power Association, Public Power in Illinois — https://www.publicpower.org/public-power-illinois (accessed 2026-10-23)
- ComEd outage map — https://www.comed.com/outages/experiencing-an-outage/outage-map (accessed 2026-10-23)
- GSHA Services service-area page — https://gshaservices.com/about-gsha-services/service-area/ (accessed 2026-10-23)
